If your drains back up when it rains, water is getting into your sewer line that shouldn’t be there. The usual causes are a cracked or broken lateral, a missing cleanout cap, or a gutter or yard drain tied into the sewer. Sometimes the city main in the street is overloaded too, and your low drains are the first place it shows.
In a dry year you might never notice. Then the first big storm hits and the shower drain fills up.
Why rain shows up in a sewer line
A sewer line is supposed to carry only what goes down your drains. Rain is supposed to go to the street and the storm drains. They’re separate systems.
When rainwater finds its way into the sewer, the pipe suddenly carries a lot more than it was built for. If the line is already partly blocked by roots or a sag, it can’t keep up. The water backs up to the lowest drain in the house.
The common ways water gets in
Cracks and open joints in an old lateral
A lot of older LA homes still have clay sewer laterals. Clay comes in short sections with joints. Over decades, roots open those joints and pipes crack. When the ground gets soaked, water seeps in through every gap.
The same gaps let roots in. So a line that backs up in the rain often has roots too. Our page on root intrusion and hydro jetting covers that side.
A missing or broken cleanout cap
The cleanout is the capped pipe outside where a plumber gets into the line. If the cap is gone or cracked, and it sits low in the yard or a planter, rainwater pours straight in.
This one is cheap to fix. A new cap. Our post on sewer cleanouts in LA explains where to find yours.
Gutters or yard drains tied into the sewer
In some older houses, someone ran a downspout or a yard drain into the sewer line. It seemed like a tidy way to get rid of water. It isn’t allowed. The California Plumbing Code prohibits storm water draining into the sanitary sewer.
It also makes a big storm dump a roof’s worth of water into your sewer at once.
The city main is surcharged
In a heavy storm, the public sewer in the street can run very full. When that happens, the water level in your lateral rises too. If your lowest drain sits low compared to the street, it can back up even if your line is fine.
That’s what a backwater valve is for. It lets sewage flow out and stops it from flowing back in.
What to do during a backup
- Stop running water in the house. No laundry, no dishwasher, fewer flushes.
- If you can find the cleanout and it’s safe, opening it can let the backup spill outside instead of inside. It doesn’t fix the cause.
- Don’t pour chemical drain cleaner into it. It won’t help with rainwater or a broken pipe.
- Take photos and note the time. It helps whoever comes out, and your insurer if you file a claim.
How to find the cause
Get the line on camera, ideally after the line is cleared and before the next storm. The footage shows cracks, open joints, roots, sags, and any connection that shouldn’t be there. Our sewer camera inspection page explains what we look for.
Also walk the outside of the house:
- Find the cleanout. Is the cap there and tight?
- Follow each downspout. Does it go to the yard or the street, or disappear into the ground near the sewer line?
- Check yard drains in low spots. Where do they go?
What the fix usually is
- Missing cap: replace it. Raise it above grade if it sits where water pools.
- Downspout or yard drain into the sewer: disconnect it and send the water to the yard or the street.
- Cracked lateral or open joints: depends on the camera. Some lines can be lined. Some need replacement.
- Low drains and a full city main: a backwater valve, if the layout allows.
Here’s the part you don’t always need. If the camera shows the line is sound and the cause was a missing cap or a gutter tie-in, you don’t need a new sewer line. Fix the small thing and watch the next storm.
Who’s responsible
In Los Angeles, the lateral is the owner’s responsibility all the way to the city main, including the part under the sidewalk and street. The city maintains the main itself. Work in the street needs extra permits. Our sewer permits page covers how that works.
Questions we get
Why does my shower drain back up only when it rains?
Rainwater is getting into the sewer line, or the city main is running full. The shower is usually the lowest drain, so it shows first.
Can I connect my downspout to the sewer?
No. Storm water isn’t allowed into the sanitary sewer. Send it to the yard or the street.
Do I need a backwater valve?
If your lowest drains sit low compared to the street and you’ve had backups, it’s worth asking about.
Will hydro jetting fix a rain backup?
It can clear roots and buildup. It won’t seal cracks that let water in.
Backing up every time it rains? Contact LA Sewer Line Pros. Tell us how old the house is and which drain backs up first. We’ll tell you whether it’s a cap, a gutter, or the line itself.